If it passes the above test, the hardware has passed a basic minimal test. If your cable fails the above test, it will almost certainly need to come back to us for repair. Moates has a ' ALDL Echo Test Program ,' which tests your ALDL cable when it is not hooked into vehicle you will have to power up the cable with 12Volts when doing.
#Make aldl cable serial#
Finally, click the “Test For Valid Interface Using Settings” to perform a test on the cable. If anyone buys one of those ALDL Cables with a serial interface, this information may be of interest, if stuff happens.Next, select “Configure Plug-in Component” Then make sure “Standard Serial” is selected and the COM port shown matches the COM port of your cable. Then make sure “TunerPro Data Acquisition I/O Interface” is selected.
#Make aldl cable software#
Includes AutoProm device, 28-pin 18-inch emulation cable, OBD1-style ALDL cable CABL1, 6-ft USB cable, 2x 27SF512 chip, and Mark Mansur's TunerPro RT5 software license. Has 3-channel 0-5v 10-bit A/D provision fpr wideband and other datalogging.
Take a look at the OBD1 GM section of our online store here Test Procedure
The ALDU1 is compatible with the CABL1 and the CABL2, which are interface cables that connect to GM OBD I and OBD II vehicle respectively. Here are a number of highest rated Diy Aldl Cable pictures on internet.
The ALDU1 is a datalogger designed to work with OBD I GM vehicles.